Skip to the beginning of the images gallery

Performer Intake Manifold for 1985-95 GM 90° V6 (3.8L & 4.3L)

$358.95

Performer 4.3L 90 Deg V6 Intake Manifold for 1985-95 Automotive & Marine 200-229-262 c.i.d.(3.8L and 4.3L) GM V6s. Accepts all Marine or Automotive Waternecks, Large/Small Cap HEI & Either 4150-Sytle EPS or Holley's 8007 Carburetor. Non-EGR

In stock

SKU

2111

Details

Edelbrock Part # 2111 Performer 90 degree V6 intake manifold is designed for street and marine 1985-95 200-229-262 c.i.d. (3.8 and 4.3L) Chevy V6s. Dual bolt pattern water neck fits both automotive and marine applications. Produced 18 more horsepower than an older manifold design on 4.3L marine engine. Will not accept stock automotive carbs or 262 T.B.I. unit.

PRODUCT SPECS

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347021116
Series	Performer
Material	Aluminum
Gasket Or Seal Included	No
Vehicle Model	Chevrolet
Availability Note	Available to Order
Warranty	12 Months
RPM Range	Idle-5500 RPM
Emissions Code
Hazardous Materials Warning	WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	Recommended intake gasket: Edelbrock # 7209 or Fel-Pro # 1202 Manifold height: A-3.50", B-4.18" Carb pad height: 3.84" Carb recommendations: Edelbrock AVS2 Series or Performer Series 500cfm Port exit dimensions: 1.15" x 1.87" Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant # 1076, DO NOT USE END SEALS GASKETS. Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Finish	Satin
Rear Maximum Height	4.180 in
Single Or Dual Plane Type	Dual